Email this article Selection of Parameters of High-Speed Thermodeformation Processing of Cr-Ni-Mo Steel on the Basis of Imitation Modeling
- Authors: Kondratiev N.A.1, Khlusova E.I.1, Anisimov D.M.1, Borovskaya O.D.1
-
Affiliations:
- Kurchatov Institute
- Issue: No 1(117) (2024)
- Pages: 5-19
- Section: Metal science. Metallurgy
- URL: https://ogarev-online.ru/1994-6716/article/view/306059
- DOI: https://doi.org/10.22349/1994-6716-2024-117-1-5-19
- ID: 306059
Cite item
Open Access
Access granted
Subscription Access
Abstract
The temperature of the end of finishing stage, cooling rate and coil winding temperature are structure-sensitive parameters for bainite-grade steels in the production of plate less than 10 mm thick. Simulation modeling of high-speed thermo-deformation processing of Cr–Ni–Mo bainitic steel samples has been carried out in order to select the most rational technological modes in continuous hot rolling mills. The influence of strain rate and temperature as well as niobium and vanadium microalloying additives on phase transformations has been investigated.
About the authors
N. A. Kondratiev
Kurchatov Institute
Author for correspondence.
Email: mail@crism.ru
Doctor of Technical Sciences Patrioticheskaya St., 49, Saint Petersburg, Russia
E. I. Khlusova
Kurchatov Institute
Email: mail@crism.ru
Doctor of Technical Sciences Patrioticheskaya St., 49, Saint Petersburg, Russia
D. M. Anisimov
Kurchatov Institute
Email: mail@crism.ru
Patrioticheskaya St., 49, Saint Petersburg, Russia
O. D. Borovskaya
Kurchatov Institute
Email: mail@crism.ru
Patrioticheskaya St., 49, Saint Petersburg, Russia
References
Supplementary files
