| Issue |
Title |
File |
| Vol 37, No 4 (2016) |
Computer simulation of the friction of rough surfaces |
(Eng)
|
|
Sutyagin O.V., Bolotov A.N., Rachishkin A.A., Burdo G.B.
|
| Vol 37, No 4 (2016) |
Self-setting of forces of friction during cross rolling |
(Eng)
|
|
Kozhevnikova G.V.
|
| Vol 37, No 4 (2016) |
Effect of ratio of hardnesses, load, and roughness parameters on approach in elastoplastic contact of rough surfaces of flat parts |
(Eng)
|
|
Matlin M.M., Kazankina E.N., Kazankin V.A.
|
| Vol 37, No 4 (2016) |
Distribution of friction tangential stresses in the Courtney-Pratt experiment under Bowden’s theory |
(Eng)
|
|
Dykha A.V., Kuzmenko A.G.
|
| Vol 37, No 4 (2016) |
Intelligent method for monitoring the state of lubricating oil |
(Eng)
|
|
Markova L.V.
|
| Vol 37, No 4 (2016) |
Modeling contact of indenter with elastic half-space with adhesive attraction assigned in arbitrary form |
(Eng)
|
|
Makhovskaya Y.Y.
|
| Vol 37, No 4 (2016) |
Experimental study of wear of model friction pairs lubricated with contaminated oil |
(Eng)
|
|
Boldyrev S.V., Budarova O.P.
|
| Vol 37, No 4 (2016) |
Effect of chemical structure of aramide and polyoxadiazole fibers on friction of organoplastics |
(Eng)
|
|
Buyaev D.I., Krasnov A.P., Naumkin A.V., Yudin A.S., Afonicheva O.V., Golub A.S., Goroshkov M.V., Buzin M.I.
|
| Vol 37, No 4 (2016) |
Study of the influence of the friction clutch operability on the performance of the switch motor |
(Eng)
|
|
Smirnov N.I., Prozhega M.V., Smirnov N.N.
|
| Vol 37, No 4 (2016) |
Simulations of the working contact loads of a tillage element |
(Eng)
|
|
Skirkus R., Jankauskas V., Gaidys R.
|
| Vol 37, No 4 (2016) |
Dаmреr with а pоrоus element fоr bearing arrangements |
(Eng)
|
|
Akhverdiev K.S., Mukutadze A.M., Zadorozhnaya N.S., Fleck B.M.
|
| Vol 37, No 4 (2016) |
Predicting the propagation of damage in roller bearings of aircraft engines by vibration analysis |
(Eng)
|
|
Silaev B.M., Barmanov I.S., Danilenko P.A.
|
| Vol 37, No 4 (2016) |
Wear resistance of electrospark WC–Cо coatings with different iron contents |
(Eng)
|
|
Burkov A.A.
|
| Vol 37, No 4 (2016) |
The role of structure formation in forming the physicomechanical properties of composites of the diamond–(Fe–Cu–Ni–Sn) system |
(Eng)
|
|
Mechnik V.A., Bondarenko N.A., Kuzin N.O., Lyashenko B.A.
|
| Vol 37, No 4 (2016) |
Effect of conditions of diamond grinding on tribological behavior of alumina-based ceramics |
(Eng)
|
|
Kuzin V.V., Fedorov S.Y., Seleznev A.E.
|
| Vol 37, No 4 (2016) |
Wear resistance of cast Fe–Cr–C steels with various combinations of structural constituents at high velocities of sliding |
(Eng)
|
|
Novytskyi V.G., Loktionov-Remizovskyi V.A., Lakhnenko V.L., Panasenko D.D.
|
| Vol 37, No 3 (2016) |
Kinetics of damage accumulation in pearlitic rail steels under contact fatigue |
(Eng)
|
|
Botvina L.R., Levin V.P., Zharkova N.A., Tyutin M.R., Soldatenkov A.P., Demina Y.A.
|
| Vol 37, No 3 (2016) |
Providing the stability of the coefficient of friction of a vehicle disk brake under extreme operating conditions |
(Eng)
|
|
Osenin Y.Y., Al-Makhdi D.M., Osenin Y.I., Sergienko O.V., Sosnov I.I., Chesnokov A.V.
|
| Vol 37, No 3 (2016) |
Fretting wear of composite ceramic coating produced on D16 aluminum-based alloy using microarc oxidation |
(Eng)
|
|
Lesnevskiy L.N., Lyakhovetskiy M.A., Savushkina S.V.
|
| Vol 37, No 3 (2016) |
Electroelastic model of dry friction: Macroscopic approach |
(Eng)
|
|
Mandel A.M., Grigoriev S.N., Oshurko V.B., Solomakho G.I., Veselko S.G.
|
| Vol 37, No 3 (2016) |
Dynamic and quasi-static instability of sliding thermoelastic frictional contact |
(Eng)
|
|
Zelentsov V.B., Mitrin B.I., Aizikovich S.M.
|
| Vol 37, No 3 (2016) |
Elastohydrodynamic problem for journal sliding bearing under reciprocating motion |
(Eng)
|
|
Usov P.P.
|
| Vol 37, No 3 (2016) |
Computer simulation of the contact of rough surfaces |
(Eng)
|
|
Sutyagin O.V., Bolotov A.N., Rachishkin A.A.
|
| Vol 37, No 3 (2016) |
Mathematical modeling of individual asperity sliding on the elastic-plastic half space |
(Eng)
|
|
Donskov A.S.
|
| Vol 37, No 3 (2016) |
Kinetics of formation of boundary lubricating film in zone of facing–tool contact under metal cutting |
(Eng)
|
|
Novikov V.V., Syrbu S.A.
|
| 301 - 325 of 366 Items |
<< < 8 9 10 11 12 13 14 15 > >>
|
