Email this article Selection of Materials of Friction Lining Centrifugal Brake Rollers
- Authors: Nosko A.L.1, Safronov E.V.1, Kirillov D.V.1
-
Affiliations:
- Bauman Moscow State Technical University
- Issue: Vol 40, No 3 (2019)
- Pages: 218-222
- Section: Article
- URL: https://ogarev-online.ru/1068-3666/article/view/229291
- DOI: https://doi.org/10.3103/S1068366619030085
- ID: 229291
Cite item
Open Access
Access granted
Subscription Access
Abstract
Abstract—The results of friction-wear tests of rolled friction-polymer materials (FPM) of two types using the operating modes of the friction brake of a centrifugal type roller are presented in this work. The tests were performed on the Nanovea T50 tribometer according to the pin-on-disk scheme. Experimental dependences of temperature, coefficient of friction and wear on the pressure on the friction lining have been obtained. The stability of the coefficient of friction of the FPM/Steel friction pair was evaluated. Comparison and analysis of the results have been performed and recommendations on the application are presented.
About the authors
A. L. Nosko
Bauman Moscow State Technical University
Email: gen-s@mail.ru
Russian Federation, Moscow, 105005
E. V. Safronov
Bauman Moscow State Technical University
Author for correspondence.
Email: gen-s@mail.ru
Russian Federation, Moscow, 105005
D. V. Kirillov
Bauman Moscow State Technical University
Email: gen-s@mail.ru
Russian Federation, Moscow, 105005
Supplementary files
