Structural-Phase Features of Low-Stability Pre-Transitional States of BCC-Alloys with Complexes of Planar Defects (Antiphase Boundaries)

Using the Monte Carlo method, the influence of the complexes of antiphase boundaries (APBs) (a pair of shear APBs and a pair of thermal APBs) on the low-stability, pre-transitional states of BCC-alloys is considered by the example of a conventional copper alloy CuZn and an intermetallic compound NiAl. It is shown that in the region of low-stability structural-phase states the energy of formation of a complex of thermal APBs is higher than that of shear APBs. The contribution of APBs into disordering is appreciable up to the structural-phase transition temperature. The most significant factor in terms of the long-range order is the formation of the defect itself; the differences in the APB type or the plane of their occurrence do not so much affect the longrange order behavior with the temperature variation. The type of APBs however appreciably affects the structural-energy characteristics of the system at the temperatures below the phase transformation temperature. Logically, a system with structural defects is less ordered than a defect-free system. The presence of a defect favors the onset of disordering at lower temperatures: it starts at lower temperatures in the case of thermal APBs (TAPBs) compared to shear APBs (TAPBs). In a BCC-system with a complex of TAPBs the first signs of disordering invariably appear near the phase boundary in the neighborhood of large atoms (Zn–Zn in the CuZn alloy or Al–Al in the NiAl intermetallide). In the alloy with a complex of shear APBs the distortion of ordering at low temperatures is observed in the regions where the boundaries cross. The presence of antiphase boundaries affects the alloy stability under heating. It is shown that disordering is accompanied by smearing of the boundaries and their faceting. It follows from a comparative analysis of the peculiarities of disordering in the BCC-system under study (classical alloy CuZn and intermetallide NiAl) under conditions of higher temperatures in the region of low-stability, pre-transitional states that the order – disorder phase transition in the CuZn alloy takes place as a result of disordering of the system, while in the intermetallide NiAl the change of long-range order results from the structural-phase transition.