Enviar artigo por via de e-mail Modeling Stamping to Determine the Impact Energy of the Hammer and the Locations Where Defects Form
- Autores: Shlyapugin A.G.1, Zamotaev K.S.1
-
Afiliações:
- Samara State Aerospace University (National Research University)
- Edição: Volume 60, Nº 1-2 (2016)
- Páginas: 131-135
- Seção: Article
- URL: https://ogarev-online.ru/0026-0894/article/view/238091
- DOI: https://doi.org/10.1007/s11015-016-0262-2
- ID: 238091
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
The operation of stamping is modeled in the software suite DEFORM-3D to determine the impact energy required of the hammer to completely fill the die in a single impact. The flow of the metal during stamping is analyzed and the probability of defect formation is estimated.
Palavras-chave
Sobre autores
A. Shlyapugin
Samara State Aerospace University (National Research University)
Autor responsável pela correspondência
Email: alex_shag@mail.ru
Rússia, Samara
K. Zamotaev
Samara State Aerospace University (National Research University)
Email: alex_shag@mail.ru
Rússia, Samara
Arquivos suplementares
