Отправить статью по E-mail Microstructure and Fracturing Behavior of AA7075–T651 Aluminum Alloy Cooled During Friction Stir Welding
- Авторы: Rao T.S.1, Rao S.R.2, Reddy G.M.3
-
Учреждения:
- Department of Mechanical Engineering, KKR and KSR Institute of Technology and Sciences
- Department of Mechanical Engineering, SSN College Engineering
- Metal Joining Group, Defense Metallurgical Research Laboratory
- Выпуск: Том 61, № 5-6 (2019)
- Страницы: 379-386
- Раздел: Article
- URL: https://ogarev-online.ru/0026-0673/article/view/236660
- DOI: https://doi.org/10.1007/s11041-019-00433-y
- ID: 236660
Цитировать
Открытый доступ
Доступ предоставлен
Только для подписчиков
Аннотация
Friction-stir-welded joints of 16-mm-thick plates of AA7075 aluminum alloy have been studied. The macrostructure of the weld region over the thickness of the plates and microstructures of various regions of the welded joint were determined using optical and transmission electron microscopes. Tensile testing of the welded samples was conducted, and the average values of the ultimate strength and yield point, as well as relative elongation were calculated. The Vickers hardness profiles in the middle of the cross-section of the welded joint were measured. Friction stir welding with forced cooling (by a compressed air flow or water immersion) was tested to reduce heat damage and improve mechanical properties. The efficiency of such welding has been demonstrated.
Об авторах
T. Rao
Department of Mechanical Engineering, KKR and KSR Institute of Technology and Sciences
Автор, ответственный за переписку.
Email: srinutadivaka@yahoo.com
Индия, Guntur, Andhra Pradesh, 522 017
S. Rao
Department of Mechanical Engineering, SSN College Engineering
Email: srinutadivaka@yahoo.com
Индия, Kalavakkam, Tamil Nadu, 603 110
G. Reddy
Metal Joining Group, Defense Metallurgical Research Laboratory
Email: srinutadivaka@yahoo.com
Индия, Hyderabad, Telangana, 500 058
Дополнительные файлы
