Email this article An Advanced Design of a Boring Bar for Grinding the Cylinder Plugs of the U8-6MA2 Drilling Pump
- Authors: Iskenderli I.N.1, Narimanov V.A.2
-
Affiliations:
- Institute of Machine Design Technology (formerly VNIIPTNeftemash)
- Azerbaidzhan Technical University
- Issue: Vol 54, No 7-8 (2018)
- Pages: 513-520
- Section: Article
- URL: https://ogarev-online.ru/0009-2355/article/view/236333
- DOI: https://doi.org/10.1007/s10556-018-0509-9
- ID: 236333
Cite item
Open Access
Access granted
Subscription Access
Abstract
Methods of restoring the internal surfaces of cylinder plugs of the U8-6MA2 drilling pump with the use of an advanced design of a boring bar possessing a complicated cross-section are proposed. The rigidity and maximal flexure of a boring bar with a machine milled surface are calculated. The economic efficiency of the proposed design is demonstrated, with a 30–40% increase in productivity.
About the authors
I. N. Iskenderli
Institute of Machine Design Technology (formerly VNIIPTNeftemash)
Author for correspondence.
Email: varsan42@mail.ru
Azerbaijan, Baku
V. A. Narimanov
Azerbaidzhan Technical University
Email: varsan42@mail.ru
Azerbaijan, Baku
Supplementary files
