Enviar artigo por via de e-mail Use of 3D Printing in the Orthopedic Prosthetics Industry
- Autores: Golovin M.A.1, Marusin N.V.1, Golubeva Y.B.1
-
Afiliações:
- Federal Scientific Center of Rehabilitation of the Disabled named after G. A. Albrecht, Ministry of Labor and Social Protection of the Russian Federation
- Edição: Volume 52, Nº 2 (2018)
- Páginas: 100-105
- Seção: Article
- URL: https://ogarev-online.ru/0006-3398/article/view/235514
- DOI: https://doi.org/10.1007/s10527-018-9792-1
- ID: 235514
Citar
Acesso aberto
Acesso está concedido
Somente assinantes
Resumo
We review additive techniques used for manufacturing orthopedic prosthetic devices. Studies using 3D scanners and built-in software are assessed. 3D scanners are analyzed after developing a scanning method and a method of assessing convenience and scan quality. Software for modeling orthopedic prosthetic devices is discussed.
Sobre autores
M. Golovin
Federal Scientific Center of Rehabilitation of the Disabled named after G. A. Albrecht, Ministry of Labor and Social Protection of the Russian Federation
Autor responsável pela correspondência
Email: muxagolovin@gmail.com
Rússia, St. Petersburg
N. Marusin
Federal Scientific Center of Rehabilitation of the Disabled named after G. A. Albrecht, Ministry of Labor and Social Protection of the Russian Federation
Email: muxagolovin@gmail.com
Rússia, St. Petersburg
Yu. Golubeva
Federal Scientific Center of Rehabilitation of the Disabled named after G. A. Albrecht, Ministry of Labor and Social Protection of the Russian Federation
Email: muxagolovin@gmail.com
Rússia, St. Petersburg
Arquivos suplementares
